You are not logged in Total: 7journals, 20,272articles Online
AccountAccount
Login / Register
Forgot Login?
 
Main menuMain menu
What's new
Journal list
Visiting ranking
Phrase ranking
Polls
About us
 
SearchSearch
 
Journal Site
Advanced Search
 

Home  >  Journal list  >  MATERIALS TRANSACTIONS  >  Vol.56  No.2 (2015)  >  pp.187-192

MATERIALS TRANSACTIONS
<<Previous article Vol.56  No.2 (2015)   pp.187 - 192 Next article>>

Mechanism of End Deformation after Cutting of Light Gauge Channel Steel Formed by Roll Forming

Siti Nadiah binti Mohd Saffe1), Takuo Nagamachi2), Hiroshi Ona3)
1) Department of Mechanical Engineering, The University of Tokushima 2) Institute of Technology and Science, The University of Tokushima 3) Forming Laboratory of Flexible Light Gauge Steels

Light gauge channel steel is fabricated from a steel sheet by roll forming. Cut end deformation of the channel steel was investigated by experimentation and three-dimensional finite-element simulation. During roll-forming, concave, convex, and reverse bending deformations on a flange occur and cause bending lines to diverge from the point of contact between the top roll and the flange corner. The reverse bending deformation is caused by a bending moment and a twisting moment. These moments remain on the flange. When the channel steel is cut, the release of the bending moment results in opening at both the top end and the tail end. Then, the release of the twisting moment makes the flange close at the top end and open at the tail end. Deformations at the tail end open widely with the overlap of the two moments.


Keyword:
roll forming, channel steel, end deformation, residual stress, finite element (FE) simulation

Received: May 02, 2014
Accepted: October 31, 2014 , Published online: January 25, 2015

PDFPDF file (J-STAGE)J-STAGEJ-STAGE


SPARC Japan

Terms of Use | Privacy Policy